This is a reference hardware design to show how it is possible to build a compact camera device USB3 camera device: turning the tinyCLUNX33 SoM into a product.

Features:

• All SoM pins exposed, additional probing and voltage pins
• Inexpensive 4-layer board
• USB3 at 5 Gbit/s integrated with a Type-C port controller
• GPIO LED and push button

Connectors:

• 1 × USB-C connectors for the FPGA 5 Gbit/s interfaces
• 1 × MIPI Raspberry Pi Camera FPC connector with
• 1 × MIPI Hirose connector
• 2 × IDC 1.27mm connector for JTAG, SPI flash, I2C, GPIO
• Extra headers for EN signals and power rails

Mechanical:

• Compact form factor fitting a small device
• No-tool setup of the SoM helping factory programming
• Mounting holes matching the Raspberry Pi Camera HQ layout

Pinout

TODO: document the pinout as tables once

Parts featured

• Hirose DF37NC-30DS-0.4V 30-pin connector
• Molex 0545482271 0.50mm Pitch FFC/FPC Connector
• Diodes PI5USB30213A Type-C Dual Role Port Controller